CONVEY-ALL 1685-SP, Руководство оператора

Страница: 54 / 64

Operator’s Manual: 1600-SP Series Conveyor
4-14 Revised 06.2019
Fig 94 - Hydraulic oil reservoir
Fig 95 - Hydraulic oil filter
4.3.6 Changing Hydraulic Oil and Filter:
1. Place all controls in neutral, stop engine and
remove ignition key before maintaining.
WARNING: Hot Liquid
Engine and hydraulics must to cool before
changing the oil. Hot oil can cause burns if
it contacts exposed skin.
IMPORTANT:
Annually, have an oil sample
tested for particle count.
2. Allow the hydraulics to cool before changing oil.
Note:
It is best to change oil
while the engine is warm
to keep contaminants in suspension.
3. Place a large pan or pail under the drain plug.
The reservoir capacity is 95 Litre (25 US Gallons).
4. Remove drain plug and allow to drain for 10 min.
5. Install and tighten the drain plug.
6. Dispose of the used oil in an approved container
and manner.
7. Fill the reservoir with specified oil.
8. Place a pan under filter to catch any spilled oil.
9. Remove hydraulic oil filter, and dispose of it.
10. Fill the new filter with hydraulic oil.
11. Apply a light coat of oil to the O-ring and install
the new filter. Snug up by hand and then tighten
another 1/2 turn.
12. Run the engine for 1-2 minutes and check for oil
leaks.
13. If leaks are found around the drain plug or filter,
tighten slightly.
14. Check oil level. Top up as required.
3622000003