CONVEY-ALL 1685-SP, Руководство оператора

Страница: 52 / 64

Operator’s Manual: 1600-SP Series Conveyor
4-12 Revised 06.2019
Fig 89 - Adjustment bolts on the swing-out
4.3.4 Swing-Out Conveyor Belt Alignment:
NOTICE: Belt Damage Hazard
Alignment of the belt must be checked at
the hopper, transition and discharge. Inspect
weekly. Unaligned belt will cause damage and
void warranty.
NOTICE: Bearing Failure
If a roller is replaced, ensure both ends are
evenly aligned with the frame before running.
If not, bearing failure may occur.
The belt is properly aligned when it runs in the centre
of all rollers. As with tensioning, the alignment should
be checked weekly, or when necessary.
WARNING: Rotating Belt Hazard
Idle the engine, then rotate the belt slowly
when checking alignment.
Turn off engine when adjusting rollers.
1. Rotate the conveyor belt slowly, and check the
position of the belt at the hopper, transition and
discharge.
Note:
If belt is out of alignment,
it will move to the loose side.
Tighten loose side or loosen tight side.
2. Adjust one side of roller at a time.
- Loosen bearing housing, then adjust the bolt.
3. Tighten the roller bearing housing.
4. Rotate the conveyor belt slowly, and check the
position of the belt on the roller.
- Repeat steps until the belt is centred.
5. Replace housing guard.
6. Continue the above process to check and adjust
the hopper, transition and discharge roller.