CONVEY-ALL 1685-SP, Руководство оператора

Страница: 15 / 64

Operator’s Manual: 1600-SP Series Conveyor
Revised 06.2019 2-7
• Chock wheels of conveyor before starting.
• Be sure that conveyor tube is empty before raising
or lowering.
• Close valves in hydraulic line when machine is in
position or before transporting.
• High winds may overturn conveyor. To avoid
damage to structures and equipment, do not raise
conveyor fully in windy conditions.
Also, do not leave the conveyor raised, when it is
not in use.
2.13 HYDRAULIC SAFETY
• Always place all hydraulic controls in neutral before
disconnecting and working on hydraulic systems.
• Make sure that all components in the hydraulic
system are kept in good condition and are clean.
• Replace any worn, cut, abraded, flattened or
crimped hoses.
• Do not attempt any makeshift repairs to the
hydraulic fittings or hoses by using tape, clamps
or cements. The hydraulic system operates under
extremely high-pressure. Such repairs will fail
suddenly and create a hazardous and unsafe
condition.
• Wear proper hand and eye protection
when searching for a high-pressure
hydraulic leak. Use a piece of wood
or cardboard as a backstop instead of
hands to isolate and identify a leak.
• If injured by a concentrated high-
pressure stream of hydraulic fluid, seek
medical attention immediately. Serious
infection or toxic reaction can develop
from hydraulic fluid piercing the skin
surface.
• Relieve pressure in hydraulic system before
maintaining or working on machine.
2.12 OPERATING SAFETY
• Be sure that anyone who will be
operating the conveyor, or working
around the unit, reads the manual. They
must know the operating, maintenance
and safety information.
Review the manual annually.
• Clean or replace all safety decals if they cannot be
clearly read and understood.
• Place all controls in neutral, and stop the engine.
Remove the ignition key. Wait for all moving parts
to stop before adjusting, repairing or unplugging.
• Keep all bystanders, especially children, away from
the machine when running.
Also, keep away when authorized personnel are
carrying out maintenance work.
• Establish a Lock-Out, Tag-Out policy for the work
site. Be sure all personnel are trained in and follow
all procedures.
Lock-out and tag-out all power sources before
servicing the unit or working around equipment.
• Be familiar with machine hazard area. If anyone
enters hazard areas, shut down machine
immediately. Clear the area before restarting.
• Keep hands, feet, hair and clothing away
from all moving and/or rotating parts.
• Do not allow riders on the conveyor when moving
or transporting.
• Keep working area clean and free of
debris to prevent slipping or tripping.
• Stay away from overhead obstructions
and power lines during operation and
transporting. Electrocution can occur
without direct contact.
• Do not operate machine when any guards are
removed.