background image

 

 

   1800

 

Continental Blvd. Suite 200 

 Charlotte, NC 28273 

   866-424-4489 

 snapone.com 

 

Innovation Science and Economic Development (ISED) Unintentional Emissions 
Interference Statement 

 

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, 
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to 
the following two conditions:  

(1) This device may not cause interference 
(2) This device must accept any interference, including interference that may cause undesired 
operation of the device  

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR 
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio 
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 

(1) L’appareil ne doit pas produire de brouillage

;

 

(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 
susceptible d’en compromettre le fonctionnement. 

 

FCC Part 15, Subpart C / RSS-247 Intentional Emissions Interference Statement 

 
Compliance of this equipment is confirmed by the following certification numbers that are placed 
on the equipment: 
 

Notice: 

The term “FCC ID:” and “IC:” before the certification number signifies that FCC and 

Industry Canada technical specifications were met.   
 
FCC ID: 2AJAC-CORE3 
IC: 7848A-CORE3 

 

This equipment must be installed by qualified professionals or contractors in accordance with 
FCC Part 15.203 & IC RSS-247, Antenna Requirements.  Do not use any antenna other than the 
one provided with the unit. 
 

Operations in the 5.15-5.25GHz band are restricted to indoor usage only. 

Caution :

 

(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the 
potential for harmful interference to co-channel mobile satellite systems; 

(ii) 

the

 maximum antenna gain permitted for devices in the band 5725-5850 MHz 

shall be such 

that the equipment still complies with the e.i.r.p. limits specified for point-to-point 

and

 

non-point-to-point operation as appropriate; and 

 

(iii) Users should also be advised that high-power radars are allocated as primary users (i.e. 
priority users) of the bands 5650-5850 MHz and that these radars could cause interference 
and/or damage to LE-LAN devices. 

Avertissement: 

(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une 
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de 
satellites mobiles utilisant les mêmes canaux; 

Содержание CORE-3












Отзывы: