background image

 

 

   1800

 

Continental Blvd. Suite 200 

 Charlotte, NC 28273 

   866-424-4489 

 snapone.com 

 

 

 

11.  Refer all servicing to qualified service personnel. Servicing is required when the 

apparatus has been damaged in any way, such as power-supply cord or plug is 
damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus 
has been exposed to rain or moisture, does not operate normally, or has been dropped. 

  

Confiez toutes les réparations à un personnel qualifié. Une réparation est nécessaire 
lorsque l'appareil a été endommagé de quelque façon que ce soit le cordon 
d'alimentation ou la fiche est endommagé, du liquide a été renversé ou si des objets sont 
tombés dans l'appareil, l'appareil a été exposé à la pluie ou à l'humidité, ne fonctionne 
pas normalement, ou s'il est tombé. 

 

12.  Protect the power cord from being walked on or pinched particularly at plugs, 

convenience receptacles, and the point where they exit from the apparatus. 

  

Protégez le cordon d'alimentation ne soit piétiné ou pincé, en particulier au niveau des 
fiches, des prises et au point où il sort de l'appareil. 

 

13.  This equipment uses AC power which can be subjected to electrical surges, typically 

lightning transients which are very destructive to customer terminal equipment connected 
to AC power sources.  The warranty for this equipment does not cover damage caused 
by electrical surge or lightning transients.  To reduce the risk of this equipment becoming 
damaged it is suggested that the customer consider installing a surge arrestor. Unplug 
this apparatus during lightning storms or when unused for long periods of time. 

 

  

Cet équipement utilise la puissance AC qui peuvent être soumis à des surtensions 
électriques, la foudre généralement transitoires qui sont très destructives envers les 
équipements terminaux connectés à des sources d'alimentation CA. La garantie de cet 
appareil ne couvre pas les dommages causés par les surtensions électriques ou 
transitoires de foudre. Pour réduire le risque de cet équipement devient endommagé, il 
est suggéré que le client envisager l'installation d'un limiteur de surtension. Débranchez 
cet appareil pendant les orages ou lorsqu'il n'est pas utilisé pendant de longues périodes 
de temps.

 

 

14.  To completely disconnect unit power from the AC mains, remove the power cord from the 

appliance coupler and/or turn off the circuit breaker. To reconnect power, turn on the 
circuit breaker following all safety instructions and guidelines. The circuit breaker shall 
remain readily accessible.  

Pour débrancher complètement l'alimentation secteur du réseau secteur, retirez le 
cordon d'alimentation du coupleur de l'appareil et / ou éteignez le disjoncteur. Pour 
reconnecter l'alimentation, allumez le disjoncteur en suivant toutes les consignes et 
consignes de sécurité. Le disjoncteur doit être facilement accessible. 

 

15.  This product relies on the buildings installation for short-circuit (overcurrent) protection.  

Ensure that the protective device is rated not greater than: 20A.

 

 

Ce produit repose sur l'installation des bâtiments pour les courts-circuits (surintensité) de 
protection. Assurez-vous que le dispositif de protection est assignée ne dépassant pas: 
20A.

 

 

16. 

WARNING – Power Sources, Grounding, Polarization

 

Содержание CORE-3












Отзывы: