Continuum Surelite EX 10, Руководство по эксплуатации и обслуживанию

Страница: 48 / 114

Continuum Surelite Laser
38 996-0207
Note: For Surelite
III
Secure harmonic generator housing to the support bracket on the graphite structure
with an M4x10 mm bolt, flat washer and lock washer.
7. Remove the cover plate for the SLT or SLF adjustment knob.
8. Reinstall laser housing cover.
Removal
N
ECESSARY
E
QUIPMENT
•
2.5 mm Allen key
•
Phillips #2 screwdriver
S
TEPS
1. Shut the system down by performing Daily Shutdown Procedure. See page 28 .
2. Remove the laser housing assembly cover that is held on by the two Phillips head screws
at each end.
3. While holding the harmonic generator do the following:
•
SLD-1 - use a 2.5 mm Allen key to remove the 3 deeply recessed (~35 mm) M3 Allen
bolts located in the mounting holes on the output face. See drawings on page 39 .
•
SLD-2 - use a 2.5 mm Allen key to remove the 3 deeply recessed (~35 mm) M3 Allen
bolts located in the mounting holes on the output face. See drawings on page
39 .
•
SLT - turn locking collar counter clockwise until the harmonic generator is loose.
•
SLF - turn locking collar counter clockwise until the harmonic generator is loose.
4. Once the harmonic generator is loose, reach down to the heater PCB and unplug the
heater cable. Grasp the white plastic connector and pull firmly and directly away from
the board.
DO NOT pull on the cable because it will damage the connector.
Note: For the Surelite III
Remove M4 x 10 mm bolt, lock washer, and flat washer from the support bracked
attached to the graphite structure.
5. Now lift harmonic generator up and out of the laser bench, wrap the harmonic generator
in lens tissue, put it in a plastic bag, and store it in a desiccator.
6. Reinstall the cover plate for the SLT or SLF adjustment knob.
7. Reinstall the laser housing assembly cover.