Continuum Surelite EX 10, Руководство по эксплуатации и обслуживанию

Страница: 39 / 114

Section 3: System Operation
996-0207 29
XXX Q-switch delay setting in microseconds. Red light labeled Q-SW DELAY µs
next to LED display should also be on. This value indicates the time between
the command to fire the flashlamp and the command to fire the Pockels cell.
The normal value is listed in the QA in front of the manual.
Pxx Flashlamp discharge divider for laser output. Take the frequency of
flashlamp discharge and divide it by Pxx to get the frequency of laser output.
(Example: Fxx = F10 and Pxx = P05 then for every fifth discharge of the
flashlamps you get laser output. The system lases at 2 Hz) This feature allows
user to change the frequency of laser output without changing the flashlamp
discharge rate. The value of Pxx can be changed from 0-99 by pressing the
ARROW UP or ARROW DOWN buttons. Normal value for Pxx is P01.
XXX Flashlamp discharge voltage in kilovolts. Red light labeled VOLTS KV next
to LED display should also be on. This indicates the charge voltage of the
laser head flashlamp capacitor. The normal value is listed in the QA in front
of the manual.
SoF Indicates that the serial mode of operation through the RS232 port is off and
the system is running on its own internal clock commands.
Son Indicates that the serial mode of operation through the RS232 port is on and
the system will await indicated input commands to operate. (See page 42 .)
EoF Indicates that the external mode of operation through the EXTERNAL
connector is off and the system is running on its own internal clock
commands.
Eon Indicates that the external mode of operation through the EXTERNAL
connector is on and the system will await indicated input commands to
operate. (See page 42 .)
Error messages
There are nine programmed error messages. When they appear, they are accompanied by
flashing and beeping. The definitions for the error messages are given below. Refer to
Table 12 Electrical troubleshooting on page 71 to resolve these problems.
E00 Normal return.
E01 Surelite not in serial mode. Serial port is turned off. To operate in serial
mode, press SELECT then ARROW UP button.
E02 Coolant flow interrupted. Check water level and kinks in water lines.
E03 Coolant temperature over temp. Cooling water temperature is too high.
E04 (not used)
E05 Laser head problems.
E06 External interlock. External interlock has opened.
E07 End of charge not detected before lamp fire.