Contec SCP-8550-LLV, Руководство пользователя

Страница: 13 / 78

2. System Reference
6
SCP-8550-LLV
Table 2.1. Functional Specifications < 2 / 2 >
Item Specification
RTC/CMOS data backed up by Lithium battery
The following table lists the Lithium battery specifications (button-type)
Specification
CR2450
Voltage
3V
Capacity
620mAh
Weight
6.3g
RTC /CMOS
* The backup time of the CR2450 battery is over 7 years (In main power is off, at 25 o C).
* The clock is accurate to +/- 3 minutes/month at 25ºC.
Power Management
Power management setup via BIOS
Modem Ring On/Wake On LAN
Supports PC98/PC99 ACPI Power management
Bus specification/Size(mm) CompactPCI (6U double slot) / 160.0(L) x 233.4(H)
DC Power Requirements
+5VDC±5%,
+12VDC±5% (for the heat sink fan),
+5VSB(Stand by) ±5% (Only when using the ATX power supply)
Power supply
specifications(Max.)
+5VDC 9A,
+12VDC 0.25A(for the heat sink fan)
+5VSB(Stand by) 0.5A (Only when using the ATX power supply)
(When using the Pentium M 1.6 GHz)
Operating temperature/
Operating humidity
0 - 50 ° C /20 - 90%RH (No condensation)
Storage temperature -20 - 80 ° C
Floating dust particles Not to be excessive
Corrosive gases None
Weight 680g
Supported OS
Windows XP Professional
Windows XP Home Edition
Windows 2000 Professional
*1: Each connectors of this board front panel cannot be used simultaneously with J4, J5 connector.
*2: When using the J4 and J5 connector signal, optional rear panel I/O board (SCP-RPIO-01) and the CPCI back plain
boards corresponding to rear panel I/O are required.
*3: The IDE drives (include on board HDD and CF card) can connect the primary port and the secondary port each
maximum two drives. The primary port cannot be used by Ultra DMA 66/100 mode while using on board HDD. The
secondary port cannot be used by Ultra DMA 66/100 mode while using CF card.
*4: The DVI-D connector can connect only the digital (Panel-Link) input type display. The analog RGB input type
display is not connectable.
*5: Access LED blinks at the time of access to on board HDD and CF card. It does not blink at the time of access to the
drive connect to IDE signal of J4, J5 connectors. (SCP-RPIO-01 has the access LED of the device that connected to
the IDE port of J4, J5 connectors.)