Conair TrueBlend TB500-4, Руководство пользователя

Страница: 86 / 150

Operation TrueBlend ™
84 Edition: February 2007
7.12.2 Manual cleaning:
Î Turn the power off with the main dis-
connect switch on the power cabinet
Î Disconnect compressed air
Î Open front access door and remove
the weigh bin
Î Position some type of deflector (card-
board tray) to divert material from col-
lecting in the mix chamber to an out-
side drum or bucket. Also available is
the Conair Drain Chute Accessory.
This allows the discharge valves to be
operated in the manual mode.
Î Using a “dowel rod” approximately
12 inches long, press vertically into the
respective valve opening and raise the
plunger cone to allow material to flow
from the material compartments.
Î Material will flow out of the hopper
compartment through the valve open-
ing onto the deflector and into the drum
or bucket.
Î Discharge the material completely and
clean the material hopper from the top
down.
Î You may also want to clean the mate-
rial receiver at this time while accessing
the gravity dump valve through the re-
spective blender clean out door.
Shown
with the
optional
drain
chute and
safety
interlock
The optional drain
chute is available
from Conair.
Contact Conair Parts
1 800 458 1960
From outside of the
United States, call:
814 437 6861