Conair TrueBlend TB500-4, Руководство пользователя

Страница: 121 / 150

TrueBlend ™ Maintenance and Repair
Edition: February 2007 119
9.4 Mixing chamber instructions
To Remove Mixing Chamber:
1 Turn all 1/4-turn fasteners on front panel
counter-clockwise until they release.
2 Remove front panel. Some models require
lifting the panel to clear 2 screws at bottom.
3 Remove mixing agitator by pulling straight
out. You may have to rotate the shaft as you
remove it in order to clear the front bin wall.
4 Lift front of mixing chamber to align the lock-
ing pins with the release slots.
5 Pull mixing chamber forward until the exten-
sion on the bottom of the chamber interferes
with the nylon drain port. Place hands under
chamber and lift fingers to raise the back of
the bin over the drain port. Pull bin straight
out.
To Install Mixing Chamber:
6 Align bin walls with guides and push straight
inward until the extension on the bottom of
the chamber interferes with the nylon drain
port.
7 Place hands under chamber and lift fingers to
raise the back of the bin over the drain port.
Push bin straight inward making sure the
back of the chamber passes under the tab on
the back wall of the chassis. Some models
do not have this tab.
8 Install mixing agitator by pushing straight in.
You may have to rotate the shaft as you in-
stall it in order to clear the front bin wall and
align the agitator shaft with the keyed drive
shaft.
9 Align the 1/4-turn fasteners on the front plate
with clips on chassis and install front plate.
Turn the 1/4 turn fasteners clockwise until
they tighten. Some models require the
alignment of the agitator shaft with a bearing
installed on the front plate before the plate
can be tightened.