Maintenance
I
5-3
5
Maintenance
Accessing the Thermolator Enclosure
Depending on which features, options, and additions you ordered with your Thermolator,
your Thermolator may appear different and operate differently from the illustrations and
photos shown in this user guide.
WARNING: Electrical shock and hot surface hazards.
Before attempting maintenance of any kind on the
Thermolator, you must stop the unit, disconnect and
lockout the main power supply, and allow the unit to
cool to less than 100° F {38° C}.
To access the Thermolator enclosure:
1
Remove the top panel.
2
Remove each side panel by lifting straight up
.
NOTE:
The side panels fit into slots at the bottom. Note how they fit so that reassembly will be easy.
3
Set the top panel and side panels out of the way for maintenance procedures.
Note that the right side and left side panels are unique and will only fit on the unit in
their appropriate position.
Mold
Purge
Rapid
Cool
Process
Cool Down
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Mold Purge
Flow GPM (flash)
Содержание Thermolator TW-P
