Comtrol DeviceMaster PRO, Руководство по установке и настройке

Страница: 93 / 174

DeviceMaster Installation and Configuration Guide : 2000594 Rev. F Connecting Serial Devices - 93
Connecting Serial Devices
Connecting RJ45 Devices
You can use this information to connect serial devices to RJ45 connectors.
1. Connect your serial devices to the appropriate serial port on the DeviceMaster using the appropriate
cable.
Note: Refer to the hardware manufacturer’s installation documentation if
you need help with connector pin outs or cabling for the peripheral
device.
2. If the DeviceMaster has RX/TX LEDs, verify that the devices are
communicating properly.
The RX (yellow) and TX (green) LEDs function accordingly when the cable is
attached properly to a serial device.
• After power cycling the DeviceMaster, the RX/TX LEDs are off.
• The LEDs do not function as described until the port has been opened by an application. You can use
Test Terminal to open a port or ports if you want to test a port or ports (
Testing Ports Using Test
Terminal on Page 154).
3. You can refer to Network and Device LEDs on Page 167 for information about the remaining LEDs.
Mode Serial Number Below xxxx-030000 Serial Number Above xxxx-030000
RS-232
RS-422
RX LEDs (yellow) are lit when connected to a
valid RS-232 device
TX LEDs (green) are lit during active data
transmission
RX LEDs (yellow) are lit while receiving
data
TX LEDs (green) are lit during active
data transmission
RS-485
RX LEDs (yellow) are lit while receiving data
TX LEDs (green) are lit during active data
transmission
Where xxxx is the first four digits of the product serial number.