Comtrol 99531-9, Руководство пользователя, Страница: 27 / 160

DeviceMaster PNIO | UP User Guide : 2000639 Rev. A Preparing the DeviceMaster for Configuration - 27
Preparing the DeviceMaster for Configuration
11. Select the Comtrol Ethernet-attached products that you want to locate and
then click
Scan
.
Note: If the Comtrol Ethernet-attached product is not on the local segment
and it has been programmed with an IP address, it will be necessary to
manually add the Comtrol Ethernet-attached product to PortVision DX.
12. Go to Step 5 in the next section, Configuring the Network Settings , to program
the DeviceMaster network settings.
If you need additional information about PortVision DX, refer to the Help system.
Configuring the Network Settings
Use the following procedure to change the default network settings on the
DeviceMaster for your network.
Note: Technical Support advises configuring one new DeviceMaster at a time to
avoid device driver configuration problems. If you want to configure
multiple DeviceMasters using the
Assign IP to Multiple Devices option, see
Configuring Multiple DeviceMasters Network Addresses on Page 129.
The following procedure shows how to configure a single DeviceMaster connected
to the same network segment as the Windows system. If the DeviceMaster is not
on the same physical segment, you can add it manually using
Adding a New
Device in PortVision DX on Page 129.
1. If you have not done so, install PortVision DX ( Installing PortVision DX on
Page 24).
2. Start PortVision DX using the
PortVision DX
desktop shortcut or from the
Start
button, click
Programs > Comtrol > PortVision DX > PortVision DX
.
3. Depending on your operating system, you may need to click Yes to the Do you
want to allow the following program to make changes to this computer? query.
You can save time if you only scan for DeviceMasters.
Default Network Settings
IP address:
192.168.250.250
Subnet mask:
255.255.0.0
Gateway address:
192.168.250.1