Comtech EF Data KPA-020IN, Инструкция по установке и эксплуатации

Страница: 68 / 99

Ku-Band Solid-State Power Amplifier Revision 0
Remote Control MN/KPA.IOM
6-9
6.9 Command/Response Pairs
6.9.1 Utility Commands
Time Set Time:
Confirmation:
Retrieve Time:
Confirmation:
<DEV/TIM_hh:mm:ss'cr'
>DEV/TIM_hh:mm:ss 'cr'' lf']
<DEV/TIM_'cr'
>DEV/TIM_hh:mm:ss 'cr'' lf'] Where: hh = Hour
mm = Minutes
ss = Seconds
Note: 24-hour military is used.
Date Set Date:
Confirmation:
<DEV/DAT_mm/dd/yy'cr'
>DEV/DAT_mm/dd/yy/'cr'' lf'] Where: mm = Month
dd = Day
yy = Year
Physical Address Set Physical Address :
Confirmation:
Retrieve Physican
Address:
Confirmation: <DEV/SPA_xxx'cr'
>DEV/SPA_xxx'cr'' lf']
<DEV/SPA_'cr'
>DEV/SPA_xxx'cr'' lf'] Where: xxx = 1 to 255
The default physical address is 1.
Baud Rate Set Baud Rate:
Confirmation:
Retrieve Baud Rate:
Confirmation: <DEV/SBR_xxxx'cr'
>DEV/SBR_xxxx'cr'' lf']
<DEV/SBR_xxxx'cr'
>DEV/SBR_xxxx'cr'' lf'] Where: xxxx = 300, 1200, 2400,
4800, or 9600
The default baud rate is 9600.
Parity Bit Set Parity Bit:
Confirmation:
Retrieve Parity Bit:
Confirmation: <DEV/SPB_xxxx'cr'
>DEV/SPB_xxxx'cr'' lf']
DEV/SPB_'cr'
DEV/SPB_xxxx'cr'' lf']
Where: xxxx = Odd or Even
The default parity is Even.
LCD Contrast Set Contrast:
Confirmation:
Retrieve Contrast:
Confirmation: <DEV/CON_xx'cr'
>DEV/CON_xx'cr'' lf']
<DEV/CON_'cr'
>DEV/CON_xx'cr'' lf'] Where: xx = 0 to 30
The default is contrast 15.
LCD Brightness Set Brightness:
Confirmation:
Retrieve Brightness:
Confirmation: <DEV/LCD_xx'cr'
>DEV/LCD_xx'cr'' lf']
<DEV/LCD_'cr'
>DEV/LCD_xx'cr'' lf'] Where xx = 0 to 30
The default is contrast 15.
Lamp Test
KPA-020IN Test Lamps:
Confirmation:
Lamp Test Status:
Confirmation: <DEV/LAM_xxx'cr'
>DEV/LAM_xxx'cr'' lf']
<DEV/LAM_'cr'
>DEV/LAM_xxx'cr'' lf']
Where: xxx = On or Off
Equipment Type Retrieve Equipment Type:
Confirmation: <DEV/RET_'cr'
>DEV/RET_xxxxxxx yyyyy'cr'' lf'] Where: xxxxxxx = Model No.
yyyyy = Software Version
Example: >DEV/RET_K080-4045-I SW_1.02
Equipment Type is a command that retrieves
the model number and software version of the
equipment. The information cannot be
changeds by command.