1. LOCATION OF THE DEVICE
The thermostats of the
COMPUTHERM
Q8RF(TX)
multi-zone programmable
wireless type device can be freely moved in your residence. It is reasonable
to locate them in rooms used regularly or for many hours per day so that
they are in the direction of natural ventilation in the room but protected from
drought or extreme heat (e.g. direct sunlight, refrigerator, chimney, etc).
Their optimal location is 1.5 m above floor level. They can be placed on their
own stand or can be mounted on a wall.
IMPORTANT WARNING!
If the radiator valves in your flat are equipped
with a thermostatic head, adjust it to maximum temperature or replace
the thermostatic head of the radiator valve with a manual control knob
in the room where the room thermostat is to be located, otherwise the
thermostatic head may disturb the temperature control of the flat.
2. PUTTING THE THERMOSTAT INTO OPERATION,
BASIC SETTINGS
2.1 Inserting batteries
Pressing the lock on the upper side of the housing of the thermostat, remove
the back cover of the thermostat as shown in the figure below.
The battery compartment is in the inner side of the front panel of the housing.
Insert 2 AA
alkaline
batteries (LR6 type) in accordance with the diagram
in the battery compartment. After the batteries have been inserted, the
display flashes the day, time and program number as well as the adjusted
and measured temperatures. (If this information fails to appear on the display,
press the “
RESET
” button located on the main panel of the thermostat. After
the batteries have been inserted, snap the front panel of the device into the
rear panel and press the “
SET
” button. After the “
SET
” button is pressed, the
display stops flashing, the thermostat goes to the main screen and the setting
process can be started.
- 4 -
