If you do not want to activate any more switches for the selected day(s),
then press the “
PROG
” button without changing the start time of the next
switch from the default
. This way the programming of the selected
day(s) is finished, the thermostat offers another day to be programmed
and the programming can be continued from step “
c
”.
If all the switches (
PROG
‒
PROG
) are activated for the selected day(s),
then after setting the temperature value of
PROG
, the programming of
the selected
day(s) is finished, the thermostat offers another day to be
programmed and the programming can be continued from step “
c
”.
h.
The adjusted program can be saved by pressing the “
SET
” button. After
approximately 1 minute, the adjusted program is automatically saved.
Afterwards, the device goes back to the main screen.
i.
If you wish to copy the program of the day(s) selected in step “
c
” to other
days, you can easily do so using the “
COPY
” button as described in
Section 3.4
.
3.4 Using the “COPY” function
(Copying the program of a day to
other days)
• First, press the “
SET
” button to go to the main screen. Then press the
“
COPY
” button for approximately 3 seconds to activate the “
COPY
”
function. The notice
"
"
appearing in place of the time characters and
the flashing abbreviation
MON
indicating Monday shows that conditions
are ready for copying a program.
• Select the day whose program you wish to copy to another day or other
days using the large
and
buttons on the front panel of the device.
• Press the “
COPY
” button to copy the program of the selected day. After
this, the flashing of the abbreviation indicating the day that has been
copied stops and it will be visible continuously hereafter.
• Select the day to which you wish to copy the program of the day copied
beforehand using the large
and
buttons. The abbreviation of
the active day is flashing during this selection process.
• After selecting the abbreviation that indicates the day to which you wish
to copy the program, press the “
COPY
” button to copy the program.
Hereafter, the abbreviation indicating the day to which the program was
copied will be visible continuously. Following this, you can select further
days using the large
and
buttons and copy the program to
those days too by pressing the “
COPY
” button.
• Finally, press the “
SET
” button to save the modifications (if no buttons are
pressed for at least 15 seconds, the modifications will be automatically
saved). Afterwards, the device goes back to the main screen. If required, the
program of further days can be freely copied by repeating the above steps.
ATTENTION!
The “
COPY
” function is only available, if the days of the week
were programmed separately!
- 10 -
