Computer Weld Technology Micro ADM, Руководство по эксплуатации и установке

Страница: 16 / 58

1. Set Coil 2 to the “ON” condition to disable automatic arc detection.
2. Load the BCD formatted Time and Date into the value Registers 6-12.
3. Set Coil 8 to the “ON” condition. The Micro ADM™ will clear the coil
after completing the function.
4. Enable Coil 2 to resume automatic arc detection.
To read a stored weld data summary perform the following steps:
1. Set Coil 2 to the “ON” condition to disable automatic arc detection.
2. Load the desired weld summary number into Registers 19. This value
must be equal to or less than the total number of saved welds as
indicated by Register 17.
3. Set Coil 6 to the “ON” condition. The Micro ADM™ will load the stored
data into Registers 2-12 and will clear the coil after completing the
function. The data will remain in the register until the next arc on or
stored weld request.
4. Enable Coil 2 to resume automatic arc detection.
4.5 Register Definitions
Register 1: Used to indicate when a welding arc has been detected. When this
register is a 1 the Micro ADM™ controller is updating the welding parameters
with new measured values.
Register 2–6: Contains the current value for each of the welding parameters:
The following table shows the value and units of measure for each weld
parameter register:
REGISTER MEASURED PARAMETERS UNITS OF MEASURE
2 Arc On time – Time in 0.1 seconds from arc
detection (Value /10) sec.
3 Arc Voltage – Voltage measured by Volt sensor (Value/10) vdc
4 Arc Current – Welding amps measured by
Hall Sensor Value = Amps DC
5 Gas Pressure – Shielding Gas pressure from
Torch (Value * 0.1)=Kpa (psi)
6 Wire Speed – Linear wire speed measured by
encoder Value = mm/sec (ipm)
12