15
1-04
Driver’s Priority Unlock
-
The driver’s door must be isolated from the other doors. Use the
Orange/Black CN3 as your 2
nd
Unlock output.
1-05
Double Pulse Disarm Wire
– This feature turn the disarm wire into a double pulse output for
shutting down factory alarm outputs.
1-06
Ig Accessory Pulse with Disarm
– This option will pulse the ignition and accessory
wires on CN1 at the same time the disarm wire pulses. Most new Ford vehicles need the ignition
and accessory pulsed to disarm the factory alarm.
1-07
Remote Start Runtime
– This option changes the remote start run time from its default 15
minutes to 25, 45, or 3 minutes.
1-08
Auto Rearm
– This option will let you change when the vehicle will relock and rearm if the vehicle
is not started.
1-09
Trunk Output Timing
– This option changes the output time of the violet/white wire on CN3.
1-10
Unlock/Disarm With Trunk Release
– This option will change what the door locks will do upon
trunk release from the remote(s).
1-11
Trigger Start
– This option changes the amount of pulse trigger(s) needed to active the control
module as a slave unit. The default setting requires three ground or 12V+ pulses to activate.
Setting 2 changes the trigger to a double ground or 12V+ pulse. Setting 3 changes the trigger to a
single ground or 12V+ pulse to activate the remote start sequence.
2-01
Timer Start or Interval Between Cold Start
- This option dictates the time interval when the
control module will remote start.
Default 1:
Will start every 3 hours until the vehicle is remote started or started by key and run for
the set run time in option 1-08.
Option 2:
Will start every 1.5 hours until the vehicle is remote started or started by key and run
time in option 1-08.
2-02
Minimum Crank Time With Tachless Sensing
– This option will increase the standard crank
time from 0.8 seconds to 1.4 seconds when remote starting. Please keep in mind that the crank
time will increase with each try.
2-03
Ignition Controlled Locks
– When you turn this option on and have the power door locks
connected the doors will lock when you remote start or start the vehicle with the key and then
press the foot brake. When you turn the key off the doors will unlock if this feature is turned on.
The feature also requires activation from the remote. Simultaneously tap the Lock + Remote Start
buttons for a half second to activate ignition controlled door locks from the remote. The parking
lights will flash once to indicate this feature is ON.
2-04
Engine Sensing
– This module comes default in Tachless mode where it does not require a
connection to a tach wire. Setting 2 changes to the tach sensing where you will need to connect
to a wire that tests as a tach. Setting 3 changes the mode to Alternator sensing where you must
connect a wire
to the alternator’s stator wire. Setting 4 does an assumed start feature where the
control module will automatically crank the yellow starter wire for 3 seconds. Please see the
“Common Procedures” section on page 6-7 of this manual for complete explanations on the four
engine sensing modes.
Содержание Firstech CM800-S
Страница 9: ...9 CM800 S Wiring Schematic Remote Start...
