CompuSTAR Firstech CM800-S, Руководство по установке

Страница: 10 / 21

10
Connector 1 (CN1), 8-Pin Ignition Harness
Pin 1
Red - Constant 12V positive (+) power input. This wire must be connected. The proper vehicle
wire will test (+) 12V at all times - while the key is in the off position, the on position and during
crank.
Pin 2
Green/White
– This is the positive (+) parking light wire that triggers when you lock and unlock
the doors and remote start the vehicle.
Pin 3 Red/White - Constant 12V positive (+) power input. This wire must be connected. The proper
vehicle wire will test (+) 12V at all times - while the key is in the off position, the on position and
during crank.
Pin 4 White - Accessory 12V positive (+) output. This wire must be connected to the vehicle accessory
/ HVAC blower motor wire. The proper wire will test 0V with the key in the off position, (+) 12V
while key is in the on position, 0V while cranking and back to (+) 12V when the key is returned to
the on position.
.
Pin 5
Blue - Positive 12V (+) output that powers up during remote start. The behavior of this wire is
selectable by a jumper inside the control module. By default this wire powers up as a 2
nd
Ignition
trigger. It is changeable to a 2
nd
Starter or 2
nd
Accessory.
Pin 6 Yellow - Starter 12V positive (+) output. This wire must be connected for remote start. The proper
wire will test 0V with the key in the off position, 0V while the key is in the on position and (+) 12V
during crank.
Pin 7
Green
– Ignition 12V positive (+) output and input. This wire must be connected to the vehicles’
ignition for remote start and valet / remote programming. The proper wire will test 0V with the key
in the off position, 12 V (+) while the key is in the on position and 12V (+) during crank.
Pin 8
Black - Ground negative (-) input. This wire must be connected to the vehicle
’s ground.
Connector 2 (CN2), 12-Pin Harness
Pin 1 Green/White - Parking light 250mA negative (-) output. The proper wire will test (-) when the
parking light switch is in the on position.
Pin 2
Red/Black
– 2
nd
Starter 250mA negative (-) output. This output can be used to trigger a relay to
power a 2
nd
Starter wire on the vehicle
– common on newer Toyotas and Nissans.