G:\Masters\Installation Sheets\AdBlue\AdBlue Laser Installation Sheet.doc
Page 13 of 23
9.
Dispensing Hoses and Nozzles
The unit may or may not be supplied with dispensing hose and nozzle assemblies.
If customer supplied hose assemblies, pylons, reels, safe breaks and nozzles are used they must
comply with the requirements outlined in AS/NZS 2229
All hoses, nozzles and fittings that come in contact with AdBlue must be compatible with it.
10.
Comms Dip-switch settings
10.1
Standard Pump Comms Setting
(Dipswitch SW3)
1-ON
2-OFF
3-ON
4-OFF
These are factory set to the standard setting unless ordered otherwise.eg Gilbarco.
10.2
Gilbarco Pump comms Setting
(Special software and interface board required)
1-OFF
2-ON
3-OFF
4-ON
11.
Triac Dip-switches
Important note:
Great care should be taken not to accidentally change the setting of these switches while
working in the Flame-proof box. Operating the unit with these incorrectly set can result in
damage to the C4000 Power Supply or incorrect operation of the triacs.
These switches are set in the factory and should not be changed.
If they are accidentally changed these are the correct settings for Laser Pump applications. Note:
They are 3 position switches
Pump (Motor triac fitted)
SW1
1
SW2
1
SW4
Centre
