Commencal ABSOLUT, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 37

QUICK RELEASE ADJUSTMENT -
META V4 REAR WHEEL AXLE
16
The tightening procedure for most of the META V4 excepts those equipped
with a Maxle axle.
1.Install the wheel in its housing in the frame. Make sure the disk is in
place between the pads.
2.Hand tighten the wing nut A until it’s locked (fig.13).
3. If the blocking position is not appropriate, loosen the small CHC screw
and tighten it until the desired position is obtained (B).
fig.13
HANDLING THE REAR WHEEL TIGHTENING SYSTEM FOR THE
SUPREME DH
- Mounting the rear wheel:
1. Install the wheel in its housing in the frame. Make sure the disk is in
place between the pads.
2. Insert the aluminum axle through the hub from the left of the frame
bracket.
3. Tighten the A axle using an 8mm Allen key (fig.14). Respect the tightening
torque listed on the axle.
4. Tighten clamp B, disc side, using a 5mm Allen key in order to lock the
shaft rotation (fig.14).
- Removing the rear wheel:
1. Loosen clamp B left side (disk) with a 5mm Allen key
2.Loosen the aluminum axle A with an 8mm Allen key.
3. Remove the axle and remove the wheel.
fig.14
WARNING ! Handling of for SUPREME FR (2012 /2013) rear wheel axle is specific.
Please refer to the tutorial available here .
BEFORE YOUR FIRST RIDER