Commencal ABSOLUT, Инструкция по эксплуатации и техническому обслуживанию

Страница: 15 / 37

15
QUICK RELEASE ADJUSTMENT -
REAR WHEEL MAXLE
®
TYPE
QUICK RELEASE ADJUSTMENT -
REAR WHEEL MAXLE
®
TYPE
1. Position the rear wheel in the frame dropout. Make sure you place the
disc between the brake pads. Hub, disc or the disc screws should not to
be in contact with the frame. Please refer to the user manual of your brake
system for more information on how to adjust the brakes.
2. Place the Maxle quick release lever in the open position (fig.11).
3. Insert the axle in the hub, left side, until it engages in the thread of the
right paw.
4. Tighten the axle in the dropout by turning the lever clockwise until it’s
filled.
fig.11
5. Close the quick release lever to check whether the tension is appropriate
to the lever (fig.12).
IMPORTANT
When closing the lever there should be resistance in the quick release system. When the lever
is closed into a horizontal position (90° to the axis) it should leave an imprint in the palm of
your hand. If this is not the case, the tension is insufficient.
6. Adjust the tension by opening the quick release lever and inserting a
2.5mm Allen key in the voltage control system in the center of the cam
lever. Rotate the control system in a clockwise direction and check the
voltage to the lever again. If necessary, repeat the procedure until the
tension lever is correct.
7. Once you have found the right setting for tension, close the quick release
lever and rotate it to put it in the desired position.
fig.12
BEFORE YOUR FIRST RIDE
IMPORTANT
Never tighten the axle with a tool.
Over-tightening of the axle can damage it and
the dropout. NOTES
This quick release system is similar to most of
the systems used on push bikes.
EN