Commander Connect Owners Manual
34
How a caller number is displayed at your Station
•
The caller’s number will appear on the 'Display' of all Keystations Programmed to ring
for incoming calls
•
If a name is associated with the number in either the system speed dial store or the
CND store the name will be displayed
•
A caller may choose to withhold their identity. In this case, the 'Display' will show
‘Number Withheld’ instead of the caller’s number or name
•
If the number information is not available the 'Display' will show ‘Number Withheld’
instead of the caller’s number or name
•
If more than one caller is calling at any one time, the number displayed will be that of
the first call in the queue. When this call is answered by one of the ringing
Keystations the number of the next call in the queue will appear on the Displays of the
other ringing Keystations
•
If your Keystation is not ringing for the call you may examine the incoming call ID by
selecting ‘Examine Incoming Call’. The same information shown on the ringing
Keystations is then displayed.
To set up your system to display caller numbers received on Analogue
lines (CND service)
If you subscribe to the Caller Number 'Display' service from your Network Provider then you can
program the system to display Analogue caller numbers.
•
From the Programming Station, press the PROGRAM Key
•
Press the Scroll Down Key (
) until ‘System programming’ is displayed
•
Select ‘System programming’
•
Enter the System Programming Password
•
Select ‘Lines’
•
Press the Scroll Down Key (
) until ‘PSTN Programming’ is displayed
•
Select ‘PSTN Programming’
•
Press the Scroll Down Key (
) until ‘CND detection’ is displayed
•
Select ‘CND detection’
•
Select the Lines that have the CND service enabled. The Lines you select will have a
♦
displayed beside them.
Press the Hands-Free Key to finish programming.
