901915-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
8
INSTALLATION
Continued
Figure 8 - Installing Grate (Pan Material Not Shown)
Figure 9 - Placement of Bottom Logs
Grate
Burner Pan
Figure 10 - Placement of Top Logs
LIGHTING
INSTRUCTIONS
OPERATING APPLIANCE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
GAS SHUTOFF
VALVE OPERATION
Flame Adjustment
Adjust the flame ON/OFF by turning the gas shutoff valve
counterclockwise
to open or clockwise
to close,
as necessary.
Shutting Off Appliance
Turn gas shutoff valve clockwise
to the OFF position.
1.
STOP! Read the safety information, above.
2.
Turn the gas shutoff valve to OFF.
3.
Wait five (5) minutes to clear out any gas. If you then smell
gas STOP! Follow the safety information above. If you don‘t
smell gas, go on to the next step.
4.
Light a match and lay it on top of the pan material about
2" from the end of the supply side of the pan
5.
Slowly turn the gas shutoff valve ON until the burner ig-
nites. If the burner doesn’t ignite within 10 seconds with
the match burning, turn the shutoff valve OFF and repeat
steps 1 through 4 again.
WARNING: Keep flue open when operating unit.
INSTALLING GRATE AND LOGS
1.
Place the grate over the burner pan. The grate should “lock”
into place over the corners of the pan (see Figure 8).
2.
Place one of the bottom logs on the grate and slide forward against
the front grate bars. Repeat for other side (see Figure 9).
3.
Place the smaller top logs onto the bottom logs (see Figure 10).
Leave as much open space between logs as possible to mini-
mize flame impingement and sooting.
Note:
Logs may chip if
they are handled roughly or if hit together while being placed.
INSTALLATION
Installing Grate and Logs
OPERATING APPLIANCE
For Your Safety Read Before Lighting
Lighting Instructions
Gas Shutoff Valve Operation
