Single brush machines
E 400 S Duo Speed
18
7.3.2 Starting work
1. Prepare the single brush machine as described in the chapter
"Tasks before starting cleaning".
2. Adjust the handle
•
Never use appliance with the guide bar in a vertical po-
sition.
3. Switch on the appliance (see Chapter “Switching on and off”).
•
Always guide the machine with both hands.
4. Slowly and carefully guide single brush machine over the surface
to be cleaned. Control machine through slight lifting or lowering of
the guide bar.
•
Moving to the left: slightly lower the guide bar,
•
Moving to the right: slightly raise the guide bar.
Pay attention to the following when working with the appliance:
•
Do not run over the mains power cable. Running over
the power supply cable with the brush rotating could
cause a fatal accident!
•
Always control the machine with both hands.
•
Move the appliance cautiously, take care to keep clear
of people and objects in the vicinity.
•
When operating the appliance never put other people at
risk.
•
When cleaning floors with the appliance, never go over
thresholds, steps or carpets or objects which might get
caught, such as cables. Max. floor gradient 10 %.
•
Never leave the appliance unattended. Keep unauthorized
persons away from the appliance.
7.3.3 On finishing work
1. When cleaning is finished, switch off the appliance (see Chapter
“Switching on and off”)
•
Hold the machine firmly with both hands until it has come to
a complete stop!
2. Bring the guide bar into the vertical position.
3. The cleaning tool must always be removed (see Chapter “Cleaning tool
attach/remove”)
4. When using a brush: Rinse the brush with clean water. If the brush is
very dirty, clean it with a suitable detergent. Allow the brush to dry.
5. When using a fluid tank: Rinse the tank out thoroughly with clear water.
Dry the machine with a cloth.
6. Keep the machine in a dry, frost-free place until it is next required.
8 Maintenance
WARNING! Risk of injury!
The appliance may put people and objects at risk. Work on and with the appliance may only be
carried out by properly qualified personnel in accordance with all the safety instructions given in
Chapter "Safety"!
–
Clean the machine with a moistened cloth (if necessary, a mild detergent may be used).
