Single brush machines
E 400 S Duo Speed
13
6.3.3 Assembling the fluid tank (Optional)
Fig. 8 Assembling the fluid tank
Risk of injury from rotating parts!
Before carrying out any assembly work, switch off the appliance
and pull out the mains plug.
1. Insert the holding device of the fluid tank (10) into the upper fixture (4)
of the guide tube (9).
2. Push the upper part of the fluid tank against the guide tube until the
snap connection (12) snaps into place.
3. Secure the connection with the swivel bracket (11). To do this, turn the
swivel bracket to the right until it is in a horizontal position. Then let it
snap into place.
4. Fit the Bowden cable (3) in the hook (2) of the dosing lever. Push the
Bowden cable into the switch housing guide (8). Apply a slight tension
to the Bowden cable using the adjusting screws.
5. Push the tube (7) onto the hose nipple (6) on the machine body.
6. Bring the tank into the optimal filling position by lowering the guide tube
(9).
1
2
Fig. 9 Filling the fluid tank
WARNING! Risk of injury!
Never exceed the maximum filling quantity of the tank. This
could cause the machine to topple over!
-{}-
WARNING! Risk of injury!
Only use cleaning agents approved by the manufacturer. Under
no circumstances may cleaning fluids be used which contain
easily combustible, inflammable, poisonous, health endangering,
corrosive or irritating materials.
ATTENTION!
The wrong cleaning agent can damage the appliance.
The following must be observed:
•
Only use cleaning agents approved by the manufacturer.
•
Never fill with fluids which are warmer than 40 °C!
7. Fill cleaning fluid through the filling opening (13) of the fluid tank.
Regulate the cleaning fluid during operation by pulling the dosing lever (1).