Single brush machines
E 400 S Duo Speed
14
6.3.4 Assembling the suction ring / vac unit (Optional)
Fig. 10 Assembling the vac unit
Fig. 11 Assembling the suction ring
Assembling the suction ring
Risk of injury from rotating parts!
Before removing the cleaning tool unplug the device!
Wear protective gloves!
1. Put the guide bar into a vertical position. To do this, pull the position-
ing lever (5) and swivel the guide bar (4) to the front. Then release
the positioning lever again.
2. Tilt the machine backwards until the switch housing
(6) rests on the
floor.
3. Put on the suction ring (1) on the machine body (3). The bristles
point away from the machine. The hose closure clip (8) must ipoint
to the left in the direction of travel.
4. Close the hose closure clip (8).
5. Point the suction device (7) to between the suction ring (1) and the
machine body (3).
Fig. 12 Assembling the suction bin
Mounting the suction tank
1. Push the mounting bracket (9) of the tank into the upper fixture (4) of
the guide bar (3).
2. Press the upper part of the tank tightly against the guide bar until the
snap connection (8) snaps in place.
3. Push the plug (6) into the socket (11) on the right side of the
appliance.
4. Plug the inlet hose of the tank (10) into the opening connection of
the suction ring (5).
NOTE!
Once the single brush machine has been switched on, the vac unit
starts automatically after a delay of about one to two seconds.
NOTE!
For further information on the vac unit (e.g. changing the paper
bag) please see the accompanying operating manual.