Columbus Instruments Exer 3/6, Руководство по оборудованию

Страница: 55 / 60

55
Treadmill Hardware Manual 1011-0002 v1.02
Simply replace the animals with the next group and press the ODOMETER RESET button. The duration counter
will be reloaded and automatically the treadmill belt mode will RUN again.
9.4.2 Speed / Mode
Turning the SPEED knob will adjust the set speed of the treadmill belt when its mode is set to STOP or RUN.
Pressing the MODE button in the following ways will change the treadmill belt mode:
•
From STOP, press and release to go to RUN.
•
From STOP, press and hold to go to ACCELERATION.
•
From RUN, press and release to return to STOP.
•
From RUN, press and hold to go to ACCELERATION.
•
From ACCELERATION, press and release to return to STOP.
•
From ACCELERATION, press and hold to go to RUN.
Stop
By default, when the AC power is switched ON, the treadmill belt mode is set to STOP. In this mode, the
treadmill belt will be disabled from running and come to rest. The current speed selected will be displayed but
the mode indicator is blank. The odometer or distance duration will not accumulate, and the time duration will
freeze to preserve the remaining time in the session.
Run
When the treadmill belt mode is set to RUN, the treadmill belt is enabled to move, and the speed can be
continuously adjusted by the SPEED knob. The display will report the set speed and the mode indicator will be
a progress bar that grows from left to right. The odometer or duration will begin to count up or down.
Acceleration
When the treadmill belt mode is set to ACCELERATION, the treadmill belt is enabled to move and the belt
speed will begin to accelerate or decelerate from its current speed toward the end speed, at the acceleration
rate indicated on the bottom of the screen. The top line will report the actual belt speed and the mode
indicator will be a staircase that grows from left to right.
9.4.3 Intensity / Rate
Turning the INTENSITY knob adjusts the electric stimulus and the current stimulus settings will be displayed on
the bottom line of the LCD screen. The information will persist for two seconds and then return to display the
acceleration settings.
Likewise, pressing the RATE button will display the current stimulus settings (without changing the repetition
rate) and will persist for two seconds. While the stimulus settings are displayed, repeated presses of the RATE
button will select the next repetition rate in the order of: 1Hz, 2Hz, 3Hz, 1Hz, etc.