Columbus Instruments Exer 3/6, Руководство по оборудованию

Страница: 24 / 60

24
Treadmill Hardware Manual 1011-0002 v1.02
•
Seconds: 0 to 59 seconds
The minimum time duration is 1 second.
3.10.3 Distance Limited
This mode limits the distance travelled in the exercise session. This is indicated by the label “L” for the distance
duration which counts down as the treadmill belt moves. When the distance duration reaches zero “0.0”, the
belt will stop. At any time, press the ODOMETER RESET button to reload the distance duration and the
treadmill belt will run again (RUN or ACCELERATION).
•
Distance: 1.0 to 9999.0 meters
3.11 Calibrate Shock
This option is used to measure and calibrate the electric stimulus. It will switch ON the stimulus continuously
(instead of pulsed) to allow a stable reading from a connected ammeter.
To measure the electric stimulus, you will need the following items:

AC ammeter (low range 0-10mA)

Alligator test leads for the AC ammeter

Alligator jumper wire

Fixed external resistance (animal body equivalent, 10,000 ohms typical, if used)
Enable the stimulus for mouse lane 1 or 6 by setting the toggle switch on the treadmill toward the lane.
Install the alligator test leads into the appropriate current-measuring terminals on the AC ammeter.
Switch ON the meter and select the range to measure no more than 10mA.
If using a fixed external resistor (animal body equivalent): Connect the red lead to one terminal of fixed
external resistor. Using the alligator jumper wire, connect the free end of the external resistor to the fourth
grid in from the end of the grids (in lane one or six).
If not using a fixed external resistor, connect the red meter lead directly to the fourth grid in from the end of
the grids (in lane one or six) Connect the black meter lead to the second grid in from the end.
This completes a closed circuit between the full-wave current source, animal body resistance, and AC
ammeter.
•
Press the ODOMETER RESET button to select the option. The screen displays:
Run to Start…
•
Press the MODE button to set the treadmill belt mode to run. The screen will display:
Stop to
Finish… Intensity: ?????
Mode: Dist Limit
100.0m S 5.0 L 100.0
A 1.0/1 E102.3