Columbus Instruments Exer 3/6, Руководство по оборудованию

Страница: 10 / 60

10
Treadmill Hardware Manual 1011-0002 v1.02

Philips screwdriver, medium tip

Flathead screwdriver, small tip

7.5mm (5/16in) wrench or adjustable crescent wrench
It is recommended to use an AC power strip to provide a common access to AC power for all components of
the Treadmill system and host computer.
2.2.1 Treadmill Assembly
The Exer 3/6 Treadmill is about 90% assembled.
•
Remove any protective plastic film that may cover pieces of the treadmill.
•
Insert spring pin into the Inclination Rod in the hole that is most near the end. This end of the
Inclination Rod is the bottom.
•
Roll the Exer 3/6 on its side.
•
Insert the top of the Inclination Rod through the hole in the front of the treadmill.
•
Roll the Exer 3/6 onto its feet.
•
Remove any protective plastic film that may cover the lane dividers.
•
Insert one of the clear lane dividers into the set of slots on the far side of the treadmill.
•
Insert all the opaque dividers into the slots in the middle of the treadmill. Leave one set of slots vacant
between the 2 dividers for rats or populate all 5 slots for mice.
•
Remove all protective plastic film that may cover the treadmill cover and lid.