Columbus Instruments Exer 3/6, Руководство по оборудованию

Страница: 53 / 60

53
Treadmill Hardware Manual 1011-0002 v1.02
8. Press and hold the ENTER button.
9. Then press and release the RESET button.
10. Release the FUNCTION and ENTER buttons.
The screen will display:
User Menu
And then position you at the top of the list of options in the menu:
➢
Serial Number
•
Run-Time Meter
•
Baud Rate
• Unit ID
•
Exit
The CHANNEL knob is used to navigate the options on the User Menu. Clockwise rotations will move the
selection arrow up, and counterclockwise rotations will move the arrow down.
Press the RESET button to select an option to edit (an underline cursor will appear to indicate you are editing)
and to save any changes (the cursor will disappear to indicate you are back to viewing).
Use the UP/DOWN knob to adjust the settings/values while editing.
Each menu option is the same as those in the Treadmill Controller User Menu.
9 – Stand Alone General Exercising without the PC
9.1 Stand Alone Initialization
Attention! Use the following procedure to prevent the application of an undesirable
treadmill belt speed or high intensity shock upon the application of AC power.
•
Disable the stimulus for all lanes by setting toggle switches toward the rear of the treadmill.
•
Switch on the Treadmill Controller. The power switch is above the AC power receptacle on the rear
panel. The front panel display should report the current speed setting, an accumulated odometer
distance of zero, and the current acceleration settings:
9.2 User Menu Settings
To start the treadmill the user must go through the User Menu and set up the experiment parameters. To
open the User Menu of the Treadmill Controller the user must:
Press and hold the RATE button.
Press and hold the MODE button.
Then press and release the ODOMETER RESET button.
S 10.0 D 0.0
A 1.0/1 E102.3
100.0m