Page 54
3.
USA — Federal Communications Commission (FCC)
3.1.
Approved wireless devices
This section presents the FCC ID and model number of the wireless device
3.2.
Preinstalled wireless LAN adapter
FCC ID: YOPGS2011MIE (Model: GS2011MIE)
3.3.
FCC ID location
3.3.1.
On the rear side of your HYDR
IM
unit, you will find an indicator label of the format
“Contains FCC ID YOPGS2011MIE”, where YOPGS2011MIE represents the FCC ID that corre-
sponds to your preinstalled Wireless LAN module.
3.4.
FCC RF Exposure compliance
The total radiated energy from the Main antenna connected to the Wireless Card conforms to
the FCC limit of the SAR (Specific Absorption Rate) requirement regarding 47 CFR Part 2 section
1093, when the unit was tested. The transmission antenna for the Wireless Card are located in the
front fascia.
3.5.
Radio Frequency interference requirements
The device has been tested and found to comply with the limits for a Class B digital device pursu-
ant to FCC Part 15 Subpart B.
Due to differences in channel allocation, if you cannot connect using the WIFI device, it may be
because these channels are not available in your region or due to interference. If this occurs, the
Ethernet connection should be used.
4.
Canada — Industry Canada (IC)
4.1.
Approved wireless devices
This section presents the IC Certification and model number of each wireless device.
4.2.
Preinstalled wireless LAN adapter
IC:9154A-GS2011MIE (Model GS2011MIE)
4.3.
Low power license-exempt radio communication devices (RSS-210)
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device. The transmitter devices have been designed to operate with the antennas
integrated in the unit, and having a maximum gain of within 3 dBi.
11. WiFi – Regulatory Information
