Page | 35
VERVE LED
Note:
Max negative value should be higher than min value eg. Min value is -0.1 then max value
should be at least -0.15.
Step 2:
Click on the MOV to change the number you need change.
Note:
The flush number means current adjust one.
Step 3:
Use the ADD button to adjust the numbers.
Step 4:
Press the ENT button to save the setting.
Step 5:
Press the ESC switch again to go to the next setting value.
Setting Procedure
–
Pressure Display Meter
Set 1 - P Protection Value
Press the SET button for one second and set the value 1
–
P with “UP” and “DOWN” button.
Note:
2-P value should be bigger than current value.
Set 2-P Protection Value
Press the SET button again, it will redirect to 2-P
Set 2-P with the UP and DOWN button.
Содержание VerveLED VLY 2513
Страница 1: ......
Страница 46: ...Page 45 VERVE LED The Right Calibration Result is shown in the image below Fig 57 The Horizontal Right Check ...
Страница 55: ......
