Page
47
of
50
SOFTJET GRAND
4002000E
LVDS Error
Check the data cable and power
supply.
40020011
EEPROM Read Failed
Re-update the FW. In case, the
problem is still, then replace the
Main Board.
40020012
EEPROM Write Failed
Re-update the FW. In case, the
problem is still, then replace the
Main Board.
40020014
Head Board is Reset
Check the power supply of the
carriage board and the data cable.
40020016
Head Board settings mismatches with
factory
Incompatible Head Board and
replace it, if required.
40020017
Board manufacturer ID doesn’t matched
with FW
Update or replace the Main Board.
40020018
Serious Error:
Exceed the time against the
time limit password
Contact the dealer for time
password expiration.
4002001A
USB1.1 connect
Kindly refer to the error code
40020001
and restart the machine.
4002001B
Serious Error:
The language of the software
setting does not correspond to authority.
Please reset the software language or input
the new language matching password again
Please reset the software language
or input the new language
matching password again.
4002001C
PINCONF writing FPGA errors.
Main Board is faulty.
40030000
USB communication error
Kindly refer to the error code
4002001A.
40030006
Printer id not supported! Please upgrade
software!
Please upgrade the software and
replace the main Board.
40030009
PRT resolution mismatch with printer
resolution!
Incorrect Print Mode is selected.
ALE 1
Overcurrent
Main circuit current is higher than
1.5
multiple
of
motor’s
instantaneous maximum current
value.
ALE 2
Over Voltage
Main circuit voltage has exceeded
its maximum allowable value.
ALE 3
Under Voltage
Main circuit voltage is below its
minimum specified value.
ALE 4
Z Pulse Shift
The
corresponding
angle
of
magnetic field of Z phase is error.
ALE 5
Regeneration Error
Regeneration control operation is
in error.
ALE 6
Overload
Servo motor and drive is
overloaded.
ALE 7
Over Speed
Mo
tor’s control speed exceeds the
limit of normal speed.
ALE 8
Abnormal pulse control command
Input frequency of pulse command
exceeds the limit of it allowable
setting value.
ALE 9
Excessive Deviation
Position control deviation value
exceeds the limit of it allowable
setting value.