5
6X-1099Z1
• Installation should be done only by qualified installers and conform to all local codes.
•
It is the user’s responsibility to ensure that the mounting methods are safe and adequate for the
location.
•
Use appropriate hardware to fasten the mount to an indoor surface.
• All servicing should be performed by qualified service personnel. Procedures in this
manual do not require entry into the housing of the camera positioning system. The unit contains
sensitive devices that can be damaged by static discharge. To reduce the risk of damage to the
unit by static discharge do not perform any servicing other than described in these instructions. If
the unit is defective, please contact the Customer Service Department for technical assistance at:
•
Liability: It is the sole responsibility of the installer to provide proper installation in compliance with
all local codes and regulations.
Safety instructions
WARNING:
PoE (Power over Ethernet) injectors used with this Camera may operate from 90-240 V AC. These volt-
ages are dangerous. Use extreme care working with equipment connected to these voltages.
CAUTION:
In order to avoid deterioration of the color filter of the CCD and potential discoloration of the image
avoid pointing the Camera directly toward the sun or other bright source.
WARNING:
Voltages that present a shock hazard may exist on Power over Ethernet circuits. Use caution to avoid
direct contact with exposed, bare Ethernet circuit conductors or connector contacts.
CAUTION:
Electrostatic sensitive electronic equipment is inside. Observe precautions for handling ESD (Electro-
static Sensitive Devices).
