7.5 Mains connection
Note that the
Panorama C
yc 1800
A
rchitectural
may function at 208V-230V-240V at 50 or 60Hz (the voltage and fre-
quency are selected as described in section 5 of this manual).
Before powering up the projector, therefore, ensure that the projector you are using matches both your request and the
voltage and frequency in use.
For mains connection, ensure your plug is rated sufficiently: 13,3 amps on startup and 9 amps during normal operation.
Connect as shown in the following diagram:
protection
The use of a thermal magnetic circuit breaker is recommended for each
Panorama C
yc 1800
A
rchitectural
.
A good earth connection is essential for the correct operation of the fixture. Strict adherence to regulatory
norms is strongly recommended.
Prior to closing up the base of the projector, proceed to the connection of the signal cable (section 8) and to
the internal settings required (sections 10 to 14); do not forget to set the DMX address, automated functio-
ning, automated program and the other options which may be selected via the multifunction display panel.
Once the projector base is closed, there is no opportunity for further access from the outside without once
again opening the base up. This is to avoid unauthorised access to the projector settings.
marrone - brown
blu - blue
giallo/verde - yellow/green
marrone - brown
blu - blue
giallo/verde - yellow/green
marrone - brown
blu - blue
giallo/verde - yellow/green
massa
gr
ound
neutr
o
neutral
fase
phase
Alimentazione
main
English
