Fire prevention:
1. Panorama C
yc 1800
A
rchitectural
utilises a Philips MSI 1800; the use of any other lamp may damage the unit and will
automatically void the warranty.
2.
Never install the unit on flammable surfaces.
3.
Minimum distance from flammable materials: 0,5 m.
4.
Minimum distance from subject being illuminated: 2 m.
5.
Replace any blown or damaged fuses only with those of identical values. Refer to the schematic diagram if there is any
doubt.
6.
Connect the projector to mains power via a thermal magnetic circuit breaker.
Prevention of electric shock:
1.
High voltage is present in the internals of the unit. Isolate the projector from mains supply prior to performing any func-
tion which involves touching the internals of the unit, including lamp replacement.
2.
For mains connection, adhere strictly to the guidelines outlined in section 6 of this manual
3.
The level of technology inherent in the
Panorama C
yc 1800
Architectural
requires the use of specialised personnel
for all service applications; refer all work to your authorised
coemar
service centre.
4.
A good earth connection is essential for proper functioning of the projector.
Never operate the unit without proper earth connection.
Protection against ultraviolet radiation:
1.
Never turn on the lamp if the lense, the filters or the aluminium housing is damaged; they will only work effectively if the are
in good condition.
Never look directly into the light beam when the lamp is on.
Safety:
1.
The projector should always be installed with bolts, clamps, and other fixings which are suitably rated to support the wei-
ght of the unit.
2.
Always use a secondary safety chain of a suitable rating to sustain the weight of the unit in case of the failure of the pri-
mary fixing point.
3.
The external surface of the unit, at various points, may exceed 150°C. Never handle the unit until at least 8 minutes have
elapsed since the lamp was turned off.
4.
Always replace the lamp if any physical damage is evident.
5.
Never install the fixture in an enclosed area lacking sufficient air flow; the ambient temperature should not exceed 35°C.
6.
A hot lamp may explode. always wait for at least 8 minutes to elapse after the unit has been turned off prior to attemp-
ting to replace the lamp.
Always wear suitable hand protection when handling the lamp.
3. Important safety information
English
