Code Alarm CA-630, Руководство по установке

Страница: 17 / 24

17
E. Programming the Tach Signal
Note: Skip this step if the vehicle does not have a tach wire or if this
unit will be programmed to operate without connection to the tach wire.
1. Open the vehicle hood (hood pin switch must be installed to
program tach).
2. Following the steps in Section C (Programming Selectable
Options), access Option Bank 4 / Feature 4 (page 18).
3. Start the vehicle with the key, and allow the engine to come to a
normal idle (5-10 seconds).
The unit will chirp the Siren/Horn and flash the parking lights every
three (3) seconds to indicate that it has learned the current idle speed.
4. System Power-Up and Programming,
cont’d
Afjustable Crank TimeTable 1.1
A d j u s t a b l e
C r a n k
T a b l e
# o f C h i r p s D u r a t i o n
1
0 . 7 4 S e c
2
0 . 8 7 S e c
3
1 . 0 S e c
4
1 . 1 S e c
5
1 . 2 S e c
6 1 . 4 S e c
7
1 . 5 S e c
5. and 6. AUX 2 5 6
Selectable times
Status LED
.5 sec.
O F F O F F
10 sec.
O N O F F
20 sec. O F F O N
10 min.
O N O N
Auxilary 2 Adjustment (Option Bank 4, Feature 5 & 6) Table 1.2
20A 20A 20A 5A
15A 15A 15A 20A
630.p65 10/17/03, 7:29 PM 17