20
5. System Testing,
cont’d
Start output configuration:
Tach Sense Mode
If Tach input wire is connected and Tach Sense Mode is enabled,
the starter will crank until the tach signal indicates that the vehicle
has started, or 4 seconds have passed. After 4 seconds, starter,
heater/AC, and ignition will shut off. The unit will pause 5 seconds,
then attempt to start the vehicle again. The start sequence will be
attempted 5 times before aborting.
Blind Crank Timing Mode
If Blind Crank Timing Mode is enabled, the module will average the
last eight key starts to determine crank time. The vehicle must be
started at least 4 times with the key to initialize an average. The
module will use this average as an assumed crank time.
Adjustable Crank Time
If No Tach Mode is enabled, the starter will crank for 1 of 7 pre-
selected times . The unit will “assume” that the vehicle has started.
You must select the time desired for each specific vehicle refer, to
pg. 20 for the time table
Note:
In Blind Crank Timing or Adjustable Crank modes, over-rev
protection is disabled if selected.
Press and hold START while vehicle is running via remote start
1. Vehicle shuts off.
2. Parking lights turn off.
3. Heater/AC and ignition shut off.
4. Defroster (or other device) turns off.
5. Impact Sensor is enabled.
Press and hold START while vehicle is running via key
1. Parking lights will turn on.
2. System will enter remote start mode. Vehicle will remain running for
the selected run time after key is removed from ignition.
Keyless Entry Operations
Press LOCK once
1. Doors lock.
2. Courtesy lights (if on) shut off.
3. Unit checks to see if doors, hood or trunk are open. If open, siren
(or horn) sounds once, parking lights flash once.
630.p65
10/17/03, 7:29 PM
20
Содержание CA-630
Страница 24: ...24 630 p65 10 17 03 7 29 PM 24 ...
