Code Alarm CA-630, Руководство по установке

Страница: 19 / 24

19
5. System Testing
1. Follow each instruction below.
2. Verify that the CA-630 operates as indicated under
each instruction.
3. Check the appropriate wire connections and/or fuses if the unit fails
to perform a specific function. Also check that any options
pertaining to the function are programmed properly.
Remote Start Operation
Press and hold START for 2 seconds
1. Unit will chirp 4 times if tach is not yet learned or vehicle has not been
manually started if in Blind Crank Timing Mode.
2. Unit will chirp two (2) times if the neutral safety input does not see
ground.
3. Unit checks to see if hood is open.
If so, parking lights flash two (2) times
and vehicle will not start.
4. Unit checks to see if brake is pressed.
If so, parking lights flash two (2) times
and vehicle will not start.
If the above conditions are not present:
1. Parking lights flash once.
2. Factory alarm (if equipped) is turned off.
3. Factory VATS or PATS systems (if equipped)
are interfaced (active output is activated).
4. Interior Sensor is disabled.
5. Vehicle ignition turns on.
6. Heater/AC are powered.
7. Vehicle starter begins to crank (heater/AC power shuts off while
vehicle starter is cranking).
8. Vehicle successfully starts.
9. Doors lock.
10.Vehicle will shut off if hood is opened, brake is pressed, or if engine
reaches 3 times its idle speed (Tach Sense Mode only). Vehicle will
also shut off if alarm is triggered.
11.Parking lights stay on for duration of run time.
12.Heater/AC is powered for duration of run time.
13.Vehicle runs for 12 or 25 minutes depending on setting of option.
630.p65 10/17/03, 7:29 PM 19