Single Color Wall Mounted ZigBee Remote Controller
70100005
55.57 mm
71.20 mm
11 mm
Function introduction
Important:
Read All Instructions Prior to Installation
Front side
Back side
Battery: CR2450
Before the first use, please remove the protective film
5
5
.5
7 m
m
7
1
.2
0 m
m
The remote control can be fixed on
the wall with 3M glue or screw.
71.2x71.2x13.6mm
Press and hold down both keys together to search and
pair to ZigBee network or factory reset the controller.
Group 1
Click to turn on. Press and
hold down to increase
light intensity.
Note: This remote
supports 4 groups for
binding max. 30 lighting
devices.
Transmission Range
(free field)
30m
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimming Range
0.1%-100%
Power Supply
3VDC (CR2450)
Operation Frequency
2.4GHz
Dimensions
Protection Type
IP20
Click to turn off. Press and
hold down to decrease
light intensity.
Group 1
Group 3
Group 3
Group 2
Group 2
Group 4
Group 4
Product Data
•
2.4 GHz global operation
•
Enables to pair ZigBee lighting devices via touchlink
commissioning without coordinator
•
Battery powered remote with low power consumption
•
Enables to control both single color lighting devices
•
Compatible with universal single color ZigBee lighting
devices
•
Supports find and bind mode to pair with ZigBee lighting
devices
•
Supports 4 groups for binding max. 30 lighting devices
•
ZigBee dim remote based on ZigBee 3.0
•
Transmission range up to 30m
•
Compatible with universal ZigBee Gateway products
•
Identify • Group
•
On/off
•
Level control
•
Ota
ZigBee Clusters Supported by This Remote Are As Follows:
Input clusters:
•
Basic
•
Power Configuration
•
Identify
•
Diagnostics
Output clusters:
Network pairing mode: click both buttons 3 times to
set the remote into network pairing mode (the remote
should not belong to any gateway network).
Factory reset: click both buttons 3 times to
reset the remote (the remote should already
be paired to a gateway).
Quick Start (Simplified operation compared to standard operations in the part “Operation”)
Tou Add Group 1:
Press and hold
down both
keys
for 3 seconds to start
touchlink and
link
light device to group 1.
Tou Add Group 2:
Press and hold
down both
keys
for 3 seconds to start
touchlink and
link
light device to group 2.
Tou Add Group 3:
Press and hold
down both
keys
for 3 seconds to start
touchlink and
link
light device to group 3.
Tou Add Group 4:
Press and hold
down both
keys
for 3 seconds to start
touchlink and
link
light device to group 4.
•
This device contains a button lithium battery that shall be stored and disposed properly.
• Do not ingest battery, Chemical Burn Hazard
• DO NOT expose the device to moisture.
• This product contains a coin / button cell battery. If the coin / button cell battery is swallowed,
it can cause severe internal burns in just 2 hours and can lead to death
• Keep new and used batteries away from children.
from children.
• If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention
• If the battery compartment does not close securely, stop using the product and keep it away
Safety & Warnings
