![background image](http://html.mh-extra.com/html/cobra/cs9/cs9_service-manual_2630323007.webp)
2
Installation
3
©
Moffat Ltd, August 2012
Revision 3
Moffat Cobra Series CS9 - Gas Salamander
Installation Requirements
NOTE: It is most important that this salamander is installed correctly and that operation is
correct before use. Installation shall comply with local electrical, gas, health and safe-
ty requirements.
Cobra Salamanders are designed to provide years of satisfactory service, and correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering gas and fire safety.
AUSTRALIA:
- AS5601
- Gas Installations.
NEW ZEALAND:
- NZS5261
- Gas Installation.
UNITED KINGDOM:
- Gas Safety (Installation & Use) Regulations 1998.
- BS6173
- Installation of Catering Appliances.
- BS5440
- 1 & 2 Installation Flueing & Ventilation.
IRELAND:
- IS 820
- Non - Domestic Gas Installations.
Installations must be carried out by qualified service persons only. Failure to install
equipment to the relevant codes and manufacturer’s specifications shown in this section will
void the warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are only
allowed to be adjusted by an qualified service person. They are not to be adjusted by the
installation person.
Unpacking
Remove all packaging and transit protection from the appliance including all protective plastic
coating from the exterior stainless steel panels.
Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
Report any deficiencies to the distributor who supplied the appliance.
Check that the available gas supply is correct to that shown on the rating plate located on the front
bottom corner of the right hand side panel.
Check that the following parts have been supplied with the appliance:
Location
1.
Installation must allow for a sufficient flow of fresh air for the combustion air supply.
Combustion Air Requirements
Natural Gas
9 m³/hr minimum.
LPG / Propane
9 m³/hr minimum.
Butane
9
m³/hr
minimum.
Town Gas
9 m³/hr minimum.
2.
Installation must include adequate ventilation means, to prevent dangerous build up of combustion
products.
1 x Salamander Rack.
1 x Wall Mounting Bracket, including;
1 x Trough Tray.
- 2 x 25mm Black Plastic Spacers.
1 x Gas Regulator.
- 2 x
3
/
8
” Bolts / Nuts.
1 x Gas Conversion Kit.
Содержание CS9
Страница 4: ... Moffat Ltd August 2012 Revision 3 Moffat Cobra Series CS9 Gas Salamander ...
Страница 35: ......