15
CAUTION:
If you tighten the front brake up too much, the brakes may hang up causing the
brake pads to wear incorrectly and prematurely.
Rear brake adjustment
Tools recommended for rear brake maintenance:
•
10mm open end wrench
There are 2 adjustments on the brake.
From the brake lever:
6. Loosen the 10mm nut on the back of the brake pedal.
7. Adjust the bolt to desirable position
8. Tighten the 10mm nut.
From the brake hub:
1. Adjust the wing nut to the desirable position.
CAUTION:
If you tighten the wing nut too much, the brakes may remain engaged. If so, the
brake pads will burn up, and need replaced.
Air Filter Cleaning
Tools recommended for air filter maintenance:
•
#2 Phillips head screwdriver
•
4 mm hex key (Allen)
•
Foam filter oil
Procedure
1. Removed the seat with the 4 mm hex key
2. Remove the filter/air inlet boot from the back of the carburetor with a flat
screwdriver
3. Pull the filter / boot assembly back, up, and out the top of the airbox.
Figure 6
, adjust brake lever free height
Figure 7
, adjust lever ‘free play’