SOLH264TX Broadcast Transmitter
H264TX, H264ENGTX, H264ENC
UNCLASSIFIED
Part A - User Guide
DS000091
Rev 1.2 2013-05-02
UNCLASSIFIED
Page 10-84
Mode 1 8b No Parity
Mode 1 8b Even Parity
Mode 1 8b Odd Parity
Mode 2 8b No Parity
Mode 2 8b Even Parity
Mode 2 8b Odd Parity
Mode 2 7b No Parity
Mode 2 7b Even Parity
Mode 2 7b Odd Parity
You can choose to leave data turned off or
select from one of the available modes.
8b (8-bit data) or 7b (7-bit data) must
match the data source, as must the parity.
Data baud rate
1200, 2400, 4800, 9600,
19200, 38400, 57600,
115200
This is the speed of serial data running
through the unit. This must match the data
source you are planning to use.
Data packet length Default
1 to 176 Bytes
In normal operation this should be left as
default.
If low end-to-end data latency is required
the data packet length can be reduced.
However this will reduce the bit rate
available for video encoding.
Chaining input
Off, On, or Relay
The default is off.
Chain no.
0, 1, 2, 3, 4, 5, 6, 7, 8, 9 The default is 0. This only becomes
important when using chaining mode.
Chaining output
Off or On
The default is on.
Current config
1 to 16
This is the Config you are currently
working on. Only 1 to 16.
Scrambling
Off, ABS, AES128,
AES256, BCrypt128,
BCrypt256
Default is off. You can select an encryption
mode here. Then you set a key.
Heartbeat enable
Off or On
Default is Off. Heartbeat On places a small
flashing block onto the video output. This
can be used to ensure the unit and link is
still operational where you have a typically
static video scene.
Metadata
Off or On
The transmitter can be made to send
metadata (like the FPGA temperature) over
the radio link. Switch this on to see this
data at the receiver On-Screen Display