SOLH264TX Broadcast Transmitter
H264TX, H264ENGTX, H264ENC
UNCLASSIFIED
Part A - User Guide
DS000091
Rev 1.2 2013-05-02
UNCLASSIFIED
Page 10-67
10.3.17
Using the Apply Button
Each time you change any parameter on the Control Application
it is very important to click the Apply button and wait for a
moment for the changes to be sent to the device.
Many times people change a parameter and then wonder why
the device has not changed behaviour. Always click the Apply
button.
10.3.18
Using the Refresh Button
If the Polling is enabled then the Control Application will
check with the device every few seconds so it can update the
Transmitter Control Window with the latest configuration
changes.
Sometimes, you may choose to leave polling off. To update
the Window in this case you’ll need to click the Refresh
Button to see the latest changes.
10.3.19
Basic Setup Pane - Quick Setup
There are several basic setup fields that enable you to do a quick setup of the unit without
getting into fine details. (We’ll meet those later).
There are the six basic things to setup:
Basic Setting
What you can do…
Output frequency (MHz)
Type in the frequency that you want this
device to use in megahertz (MHz).
If you type in a frequency which is out of
range, the unit will automatically round to
the highest or lowest frequency which
actually is available.
The transmitter frequency can be set in
step sizes of 125kHz.
Bandwidth mode
In this combo box the drop-down arrow
enables you to choose between DVB-T
and Cobham’s Narrowband modes.
Note: To select 6MHz or 7MHz DVB-T
modes the user must first click the
Advanced button to enter the Advanced
setting page.
Video Input
You can select the type of camera you
want to connect to the transmitter.