570-2000, Rev. E, 453-2000 Handheld Programmer Operations Manual
4.7.3
Serial User / Aircraft 24-Bit Addr (Short)
1.
Select ELT Baud rate.
2.
Select Protocol.
NOTE
: Country Code will be blank. It will be automatically selected by entry of
a valid 24-Bit Aircraft Address.
3.
Select the desired number system (Octal: 8 digits from 0-7 or Hex: 6 digits from
0-9 or A-F) to match the format of the 24-bit address provided.
4.
Go to Graffiti screen and tap on letter/numbers.
5.
Enter the 24-bit address.
NOTE
: The 3-digit country code is automatically determined from the country
data encoded in the 24-bit address.
6.
Enter the COSPAS-SARSAT TAC number.
7.
Enter number of additional ELTs.
This particular number field represents the number of additional ELTs on
board an aircraft, beyond the primary ELT.
Enter “0” if there is only one ELT on-board, and “1”, “2”, etc., corresponding
to the number of additional ELTs installed on the aircraft.
8.
Tap “Done” when finished.
9.
Tap “ENTER” button on Program screen. The 24-digit hex code is shown at the
bottom of the screen, with the abbreviated 15-digit hex code below it.
10.
Tap the “Program” button to program the ELT.
11.
Ensure that screen shows “Programming Successful”.
12.
Verify ELT using “Sarcalc”, as described in Subsection 6.2.
4.7.4
Serial User / Aircraft 24-Bit Addr/Ntl (Short)
1.
Select ELT Baud rate.
2.
Select Protocol.
NOTE
: Country Code will be blank. It will be automatically selected by entry of
a valid 24-Bit Aircraft Address.
3.
Select the desired number system (Octal: 8 digits from 0-7 or Hex: 6 digits from
0-9 or A-F) to match the format of the 24-bit address provided.
4.
Go to Graffiti Screen and tap on letter/numbers
5.
Enter the 24-bit address.
NOTE
: The 3-digit country code is automatically determined from the country
data encoded in the 24-bit address.
6.
Enter the National Use designated number.
Page 18
