CMP Brilliant wonders 25677 series, Руководство по установке

Страница: 4 / 10

4
Figure 1: Protective Cap and Tongue Shown on Waterfall
3.1.1 – Layout and finishing the base for a formed substrate.
The Brilliant Wonders Waterfall series has a 6” lip. With a 6” Lip, the waterfall must be installed and
supported further back into the substrate. This lip must be fully supported and is recommended to be
installed with the lip a minimum of 1/8” overhang from the finished surface. Depending on the installation,
rebar may be used to reinforce the concrete or other substrate. If using rebar in your application, it is
recommended to offset the rebar a minimum of 1 inch embedded into the substrate (typically used in
concrete). When forming an area for installation, note that a plumbing and electrical notch must be provided
(Figure 2). General Dimensions for the install are as follows: The foundation must be 2 inches wider than
the overall width of the waterfall and the plumbing notch formed to 3 ½” W x 3 ½” D in the back center for
adequate clearance. The electrical notch can be formed to 3” W x 3 ½” D from either end.
Figure 2: Concrete sample showing lip support.
Body Support Area
Leave protective covers on the waterfall face and inlet
throughout the installation (to prevent debris from getting
into the product).
BODY SUPPORT CUTOUT
(2” wider than waterfall recommended)
STEEL REBAR SUPPORT
(Recommended)
ELECTRICAL NOTCH
(3.5” W x 3.0” D recommended)
PLUMBING NOTCH
(3.5” W x 3.5” D recommended)
NOTE: Larger waterfalls have 2 or
3 inlets.