CM Lodestar XL, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 36 / 52

TESTING
Before using, all altered, repaired or used hoists that
have not been operated for the previous 12 months shall
be tested by the user for proper operation. First, test the
unit without a load and then with a light load of 50
pounds (23 kg) times the number of load supporting
parts of load chain to be sure that the hoist operates
properly and that the brake holds the load when control
is released. Next test with a load of *125% of rated
capacity. In addition hoists in which load sustaining parts
have been replaced should be tested with *125% of
rated capacity by or under the direction of an appointed
person and written report prepared for record purposes.
After this test, check that the Protector functions. If the
Protector permits lifting a load in excess of 180% of
rated load, it should be replaced.
NOTE: For additional information on inspection
and testing, refer to American National
Standard ASME B30.16 “Overhead Hoists”
obtainable from The American Society of
Mechanical Engineers, 345 East 47th Street,
New York, NY 10017 U.S.A.
*If the Protector prevents lifting of a load of 125% of
rated capacity, reduce load to rated capacity.
ORDERING INSTRUCTIONS
The following information must accompany all corre-
spondence and orders for replacement parts:
1. Hoist rated load from identification plate.
2. Serial number of the hoist stamped below identifica-
tion plate.
3. Voltage, Phase, Hertz from identification plate.
4. Length of lift.
5. Key number part from parts list.
6. Number of parts required.
7. Part name from parts list.
8. Part number from the parts list.
If trolley replacement parts are ordered, also include the
type and capacity of the trolley.
32
WARNING
Cutting Chain Can Produce Flying Particles.
TO AVOID INJURY:
• Wear Eye Protection
• Provide A Shield Over Chain To Prevent Flying
Objects
!
WARNING
Using “commercial” or other manufacturer’s parts to
repair the XL Hoists may cause load loss.
TO AVOID INJURY:
Use only factory supplied replacement parts. Parts may
look alike but factory original parts are made of spe-
cific materials or processed to achieve specific proper-
ties.
!
REPAIR PARTS
NOTE: WHEN ORDERING REPLACEMENT PARTS, IT IS
RECOMMENDED THAT CONSIDERATION BE
GIVEN TO THE NEED FOR ALSO ORDERING
SUCH ITEMS AS GASKETS, FASTENERS, INSU-
LATORS, SEALS, ETC. THESE ITEMS MAY BE
DAMAGED OR LOST DURING DISASSEMBLY
OR JUST UNFIT FOR FUTURE USE BECAUSE OF
DETERIORATION FROM AGE OR SERVICE.