4 |
EN
EN
| 5
Protective Gear
Personal Protective Equipment (PPE) must comply with the
American National Standards Institute’s ANSI Z87.1-1989 standard
if purchased after July 5, 1994, or ANSI Z87.1-1968 or with the
standard of the country in use.
• Eye and face PPE shall be distinctly marked to facilitate
identification of the manufacturer. (1910.133[a][4]).
• The following minimum requirements must be met by all
protective devices. Protectors shall:
- Provide adequate protection against the particular hazards
for which they are designed
- Be of safe design and construction for the work to be
performed
- Be reasonably comfortable when worn under the designated
conditions
- Fit snugly and not unduly interfere with the movements
of the wearer
- Be durable
- Be capable of being disinfected
- Be easily cleanable
- Be distinctly marked to facilitate identification only
of the manufacturer
RECOMMEND USE OF FULLY ENCLOSED EYEWEAR
PROTECTIONS, SUCH AS GOGGLES, WHEN USING THIS DEVICE.
ALWAYS USE APPROPRIATE PPE, LISTED ON THE CLOROX-
APPROVED PRODUCT’S SAFETY DATA SHEET (SDS).
CLOROX SDSs CAN BE FOUND AT
WWW.THECLOROXCOMPANY.COM/BRANDS/SAFETY-
INFORMATION/SDS/.
Safety Decal
This decal is located on the top-most deck surface forward of the
bottle storage location.
WARNINGS
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury
• Do not operate the unit when fatigued or
under the influence of drugs or alcohol.
• Use fluids and solvents that are compatible
with equipment wetted parts. See technical
data in all equipment manuals. Read fluid
and solvent manufacturer’s warnings. For
complete information about your material,
request SDS from distributor or retailer.
• Do not leave the work area while equipment
is energized.
• Turn off all equipment when not in use.
• Check equipment daily. Repair or replace
worn or damaged parts immediately with
genuine replacement parts from trusted
Clorox partners only.
• Do not alter or modify equipment.
Alterations or modifications void your
Clorox® Total 360® warranty and agency
approvals, and create safety hazards.
• Route hoses and power cords away from
traffic areas, sharp edges, moving parts
and hot surfaces.
WARNINGS
CHEMICAL USE HAZARD
Each chemical, such as a disinfectant, has a unique set of hazards
and needs to be handled properly to ensure worker safety.
• The Clorox® Total 360® Electrostatic Sprayer can only be used
with products that have been approved by Clorox.
Never spray
any liquid product that is not a Clorox-approved product.
The
Clorox® Total 360® Electrostatic Sprayer warranty is voided
if the Clorox® Total 360® Electrostatic Sprayer is used with
products that are not approved by Clorox. Be aware that many
chemical liquids can be harmful if they are not used properly.
• Read and understand the Clorox-approved product’s SDS and
label prior to use.
• Be aware of first-aid procedures related to the product in use.
• It is a violation of Federal law to use a chemical in a manner
inconsistent with its label.
• Use personal protective equipment as detailed by the Clorox-
approved product’s SDS.
• For use with non-flammable, non-combustible and non-volatile
fluids only. Never spray a flammable chemical (flash point less
than 140°F [60°C]) .
• Ensure the area being sprayed has proper ventilation.
• Store all chemicals in original containers in a cool, dry place,
away from heat and open flames.
• Do not reuse or refill a chemical container.
• To dispose of Clorox-approved products refer to product labels.
WARNINGS
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective equipment when in the work area
to help prevent serious injury.
• Recommend use of fully enclosed eyewear
protections, such as goggles, when using
this device.
• Refer to product specific Clorox Safety Data
Sheets (SDS) for any additional Personal
Protective Equipment (PPE).
IMPORTANT SAFETY PRECAUTIONS
When using an electrical appliance, it is important to understand
that some circuits are electrically live, even when the power switch
is in the off position. Basic safety precautions should always be
followed to reduce the risk of burns, fire, electrical shock, injury
and/or death.
Power Connection
Our power plug must be used with a three-pronged, grounded
outlet, rated for no less than 15A service. Always verify before
product use. This appliance is for use on a nominal 120V/60Hz
circuit with a verified ground plug. Check with a qualified electrician
to ensure you have the correct electrical service and grounding.
Grounding Instructions
This appliance must be grounded. In the event of malfunction
or breakdown, grounding provides a path of least resistance
for an electric current to reduce the risk of electric shock. This
appliance is equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances. Never use an
adapter with this product.
DANGER:
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The conductor with
insulation having an outer surface that is green, with or without
yellow stripes, is the equipment-grounding conductor. If repair or
replacement of the cord or plug is necessary, do not connect the
equipment-grounding conductor to a live terminal. Check with a
qualified electrician or serviceman if the grounding instructions are
not completely understood or if in doubt as to whether the appliance
is properly grounded. Do not modify the plug provided with the
appliance — if it will not fit the outlet, have a proper outlet installed by
a qualified electrician. Never use an adapter with this product.
Extension Cord
Clorox provides a 25-foot (7.6m) extension cord with each Total
360® Electrostatic Sprayer and strongly recommends that you use
this approved extension cord. Make sure your extension cord is in
good condition. Inspect cords periodically and replace if damaged.
If an alternate extension cord is used, be aware that an undersized
extension cord will cause a drop of in-line voltage, which
could result in a loss of power, damage to the product and/or
overheating. Always use a sufficiently rated extension cord.
IMPORTANT:
Clorox recommends using a 12/3 gauge extension
cord, no longer than 100 feet (30.5m). Additionally, Clorox also
recommends the use of a GFCI (ground fault circuit interrupter)
power outlet or extension cord. When equipped on the extension
cord, always position the GFCI toward the power outlet.
COVER OF
GROUNDED
OUTLET BOX*
GROUNDING
PIN
*120-volt grounded connectors shown. 220/240-volt grounded connectors will
differ in shape.
WARNING!
¡ADVERTENCIA!
AVERTISSEMENTS!
NI-45400
•
Always wear appropriate Personal Protective
Equipment (PPE), as detailed in the User Manual,
when using this device. Refer to product specific
Clorox
®
Safety Data Sheets (SDS) for any additional PPE.
•
Follow instructions and precautions listed on Clorox
®
manufacturing product labels.
•
Only use Clorox
®
-approved products through the
Clorox
®
Total 360
®
Sprayer.
•
Inspect power cord, sprayer and external tubing
for damage prior to use. DO NOT use if damage
is present.
•
Always use with a grounded electrical plug
and outlet.
•
Use device only as intended. Direct spray only
toward appropriate surfaces.
•
Cuando use este dispositivo, siempre use el equipo de
protección personal (EPP) apropiado, como se detalla
en el Manual del Usuario. Consulte las Fichas de Datos
de Seguridad (FDS) para cualquier EPP adicional.
•
Siga las instrucciones y precauciones que se listan
en las etiquetas de fabricación del producto Clorox
®
.
•
Utilice solamente productos Clorox
®
aprobados por
el Atomizador Clorox
®
Total 360
®
.
•
Antes de usarlo inspeccione el cable de electricidad,
el rociador y la tubería externa por daños. NO lo use
si hay daños presentes.
•
Siempre usarlo con un enchufe y toma de corriente
eléctrica con conexión a tierra.
•
Solamente utilice el dispositivo para lo que fue
diseñado. Solo rocié directamente en las superficies
adecuadas.
•
Au moment d’utiliser le pulvérisateur, toujours porter un
équipement de protection personnelle (ÉPP) adéquat, tel
que décrit dans le manuel de l’utilisateur. Se reporter à
la fiche signalétique du produit nettoyant Clorox
®
afin de
connaître tout autre ÉPP requis pour son emploi.
•
Suivre les instructions et les mises en garde indiquées
sur l’étiquette d’origine de chaque produit Clorox
®
.
•
Utiliser le pulvérisateur Clorox
®
Total 360
®
uniquement
avec les produits Clorox
®
approuvés à cette fin.
•
Avant l’emploi, inspecter le cordon d’alimentation,
l’appareil lui-même et les tubes externes pour
vérifier l’absence de dommages. NE PAS utiliser
le pulvérisateur en présence de dommages.
•
Toujours brancher le pulvérisateur dans une prise
de courant avec mise à la terre.
•
Utiliser le pulvérisateur strictement selon le mode
d’emploi. Toujours diriger le jet directement vers
les surfaces à traiter.
