Clinton DC-1, Инструкция по эксплуатации, Страница: 34 / 58

Models DC-1, -10, -20B DC Spark Testers
DC-1, -10, -20B Instruction Manual – Page 33
Pinhole Alarm (PHA)
This output will operate in 2 different modes, “NLC” , ”LCH” . The Pinhole alarm
will respond only to a ‘Pinhole’ fault type . See the “New Features” section of
the manual for more information on fault typing.
Pinhole Alarm Mode (PHMO)
– Non Latch Mode
The output will change state for the configured “ PHMS ” time .
– Latch Mode
The output will change state until it is reset at the front panel or
remotely.
Pinhole Alarm Time (PHMS)
Set in seconds (.01 – 5.0). If “PHMO” is set to “NLC”, this is the time for
which the output will change state.
Metal Contact Alarm (MCA)
This output will operate in 2 different modes, “NLC” , ”LCH” . The Metal Contact
alarm will respond only to a ‘direct metal contact ’ fault type . See the “Fault
Typing” section of the manual for more information.
Metal Contact Alarm Mode (MCMO)
– Non Latch Mode
The output will change state for the configured “ MCMS ” time .
– Latch Mode
The output will change state until it is reset at the front panel or
remotely.
Metal Contact Alarm Time (MCMS)
Set in seconds (.01 – 5.0). If “MCMO” is set to “NLC”, this is the time for
which the output will change state.
Multi Pinhole Alarm (MPA)
This output will operate in 2 different modes, “NLC” , ”LCH” . The Multi Pinhole
alarm will respond only to a ‘Multi Pinhole’ fault type . See the “Fault Typing”
section of the manual for more information.